Set queued request liimit to the same value you used in the previous step:.Configure max threads to either 24 or ( 3 * the total number of cores from the previous step), whichever is higher with the following command, replacing :.Determine the number of cores the server has.Exclude both this directory and SPE's installation directory from any AV scanning Use the following xmlmodifier command to get the temporary directory.Tune performance settings for Protection Engine. NOTE: The NetApp Filer does not use Protection Engine until the vscan is turned on (see below).Ħ. For C-Mode or Mixed mode, open the OnTap AV Client that is installed on the Protection Engine server and enter the LFS IP address.For 7-mode or mixed mode, add each of your 7-mode filers, repeating the following command for each filer, replacing with the filer's address:.\xmlmodifier -c 127.0.0.1 configuration.xml For C-Mode or mixed mode, add the loopback address as an rpc client:.Configure Scan Engine to register with the NetApp Filer using xmlmodifier. Restart the Symantec Protection Engine service.ĥ. Click the OK button to save the changes and close the Symantec Protection Engine Properties dialog box.Į.
#Partition magic 8.0.1 patch download windows#
On the Log On tab, enter the Windows account name and password.ĭ. Right click on Symantec Protection Engine and click Properties.Ĭ. Open the Windows Services Control Panel.ī. Use the following steps to make this change:Ī. Local admin on the Protection Engine computer Member of the Backup Operators group on the NetApp Filer The Windows account should have the following permissions: The Protection Engine Windows service should be configured with a Windows account. If the SPE server is a guest virtual machine (VM), RAM, CPU cores, and HD space resources should all be reserved for the exclusive use of the SPE guest VM.Ĥ. The SPE server must meet minimum requirements as described in the system requirements documentation.ģ.
#Partition magic 8.0.1 patch download software#
Make sure that no other networking or OS-related services and software (other than the strictly necessary ones) are installed and running on the Protection Engine server.Ģ. SPE must be restarted for any of these change to take affectġ. For these steps, you need to use an elevated command prompt from SPE's installation directory. Some of these steps require the use of the xmlmodifier tool to make configuration changes.